Assignment 4  Saw Horse Project

1. we got a rough piece of wood from the machine room where we used the buzzer to plane the width of the timber and then we used the thicknessor to plane the length of the timber.

2. after that we marked a 100 in from the edge, to get the angle we used a piece of timber that had the angle in it after marking out the angle we used it to mark on the 100mm, from the 100mm we marked 90mm for the legs, on top we marked 16mm in, from the mark on the sides.

3. after marking it all out i use the panel saw and cut in a parrarel line 0 - 16mm and then i used the chisel to chip out the pieces i cut.

4. we got the legs from the workshop, to mark it we used the the angle from the piece of timber with the 60 by 10 angle on it and then we cut out the angle.

5. after we cut out the angle we glue all four legs with pva and then we nail the legs in